Weldarc 200i Key Features
- 200 Amp AC or DC TIG
- AC TIG for Aluminium
- 170 Amp stick welder
- Quality 8m TIG torch with in-built trigger and current control
- HF Pulse start or Lift Arc start
- Pulse TIG
- Compact, lightweight design
- Suits 2-4.0mm electrodes
- 15 Amp supply plug
built in VRD (Voltage Reduction Device) delivers added safety when
operating in Stick or Lift-TIG mode and meets the requirements of site
work. Fully compliant to Australian Standards AS 60974.1 & AS1674.2
At 21kg, the Weldarc 200i can go wherever the job takes you, making it suitable
for onsite maintenance.
can be used specifically for TIG welding aluminium and aluminium
alloys. The balance between positive and negative can be adjusted to
control the amount of oxide cleaning or a more penetrating weld. When
welding in AC current HF pulse start allows easy arc starting when
DC TIG can be used for all
steel, stainless steel, copper and alloys, titanium. When welding in DC
current HF Pulse start allows easy not contact starts for critical
Intergrated Gas Valve
HF Pulse Start
HF Pulse is a non-contact arc starting
method allowing easy arc start without the interference problems with
conventional HF and eliminates tunnormalen contamination. Available in AC
or DC TIG mode.
Built-In Operator Safety
The power source
features a built-in thermal protection device that will activate if
the machine is operated beyond its safe thermal operating zone.
Hot Start for Manual Arc
Built-in “Hot Start” feature in stick mode for even better arc starting.
Built in “Arc Force”, constantly monitors arc voltage and will boost output if low arc voltage occurs.
Lift Arc TIG Start
Easy to use lift arc starting for TIG welding. Eliminates scratch starting and tunnormalen electrode damage.
Weldarc 200i is tolerant to unconditioned power from generators. It has
been optimised and tested for compatibility with appropriate portable
With a 2 year unlimited warranty,
covering parts and labour, and supported by an Australia wide
service network, you can be guaranteed you’re buying reliability and
performance. *Power source only.
Generators used to power this equipment must have a minimum capacity of 10kW continuous.
to variation between generators by different manufacturers, it is
impossible for WIA to validate operation from all generators. Therefore,
WIA recommend that operation of equipment on the generator is confirmed
before purchasing either welder or the generator.